SRM-64 magnet-free motor with driver
A 50 W class, 24 V switched reluctance motor with no magnets and no rare earths, with its three-phase driver board mounted behind it.

Switched reluctance motors turn because an iron rotor is pulled towards whichever pole is switched on. With no magnets they avoid rare-earth materials entirely and tolerate heat well, at the cost of more noise and torque ripple than a magnet motor.
SRM-64 pairs a 6-pole, 4-tooth motor with its own driver board on the back, and firmware that shares torque between phases to smooth it out at low speed.
Design figures
- Rated point
- 54 W at 6000 rpm calculated
- Efficiency with driver
- about 69 % calculated
- Peak torque
- 0.31 N·m at 500 rpm calculated
- Magnets
- None design target
- Supply
- 24 V (18 to 28 V) design target
- Size
- 68 × 68 × 100 mm design target
Nothing has been built yet, so nothing here is measured.
How it works
Iron, not magnets
The rotor is shaped iron with four teeth and no magnets at all.
Switch the poles
The driver energises pairs of stator poles in turn, pulling the nearest rotor teeth round.
Smooth the steps
Firmware blends the current between phases to reduce ripple at low speed.
10 use cases
10 of 10 use cases
- TeachingMotor drives courseShow reluctance torque, phase switching and current control on a real design.
- ResearchRare-earth-free drive researchA test platform for control methods on magnet-free motors.
- ResearchNoise and ripple studiesStudy and reduce the acoustic noise these motors are known for.
- Product developmentBlower or fan driveDrive a blower wheel where magnet supply or heat is a concern.
- Product developmentHigh-temperature driveA motor with nothing to demagnetise near a heat source.
- Manufacturing and testDriver development benchTest new driver hardware and firmware against a known motor.
- TeachingFirmware labWrite and tune commutation firmware on a ready board.
- ResearchSensorless control researchTry estimating rotor position from current alone.
- Product developmentSupply-chain test caseCompare a magnet-free option in a product before choosing a motor.
- RoboticsRugged auxiliary drivesPumps or fans on a research robot that runs hot.
Where it stands
Design concepts: none of these has been built or tested yet. Every figure is calculated, simulated, taken from a part's datasheet or a design target, and each one says which. Pictures are computer renders from the CAD models. These are our own designs of known ideas; similar products and patents exist.
Designed in-house down to circuit boards, firmware and CAD. The design is proprietary to Senova Systems and is not open source. Interested in this one for your lab or product? Our email is at the foot of every page.