Menu

HP-34 levitated lab pump

A small centrifugal pump whose magnet rotor floats inside a sealed chamber: six coils spin and centre it, and sensors on the same board track it through the wall. Nothing touches the liquid but the rotor.

Design concept · Research rig

Most small pumps have a shaft seal or a bearing in the liquid. Both wear, shed particles and can fail when the pump runs dry. Pumps with a levitated rotor avoid that, and are used where purity or gentle handling matters.

HP-34 floats a 31.6 mm magnet rotor in a sealed chamber. Six coils on a circuit board under the chamber both turn the rotor and push it back to the centre, while six magnetic sensors read its position through the wall. Up and down and tilt are held by the magnets themselves.

It is designed around ordinary bar magnets and laser-cut steel rather than custom parts.

Design figures

Flow at duty point
6 L/min at 2 m head calculated
Shut-off head
2.8 m at 4000 rpm calculated
Input power at duty point
9.1 W calculated
Rotor
31.6 mm, 25 g design target
Coast after power loss
about 0.14 s before touchdown simulated
Size
88 × 140 × 51 mm, about 321 g design target

Nothing has been built yet, so nothing here is measured.

How it works

  1. Sealed chamber

    The rotor sits in a closed chamber with the liquid; the electronics are outside it.

  2. Spin and centre

    Six coils make a turning field and also push the rotor sideways back to the middle.

  3. Sense through the wall

    Six sensors read the rotor's position through the chamber wall many times a second.

10 use cases

10 of 10 use cases

  • Lab automationCell-culture media loopsCirculate media gently, with no bearing in the liquid to grind or shed.
  • Lab automationParticle-free recirculationMove liquids where wear particles would spoil a measurement.
  • Lab automationSealed chemistry loopsPump inside a closed system with no shaft seal to leak.
  • ResearchBioreactor researchA small, low-shear pump for lab-scale bioreactor experiments.
  • ResearchMicrofluidics supplyFeed a microfluidic setup from a reservoir without pulsation from a piston.
  • Manufacturing and testCoolant loop for test rigsRun a small cooling loop where dry running could happen during setup.
  • Manufacturing and testWet-process samplingDraw samples from a process bath without seals in contact with it.
  • TeachingMagnetic bearing demoShow magnetic bearings and a motor sharing the same coils.
  • Product developmentBearingless pump evaluationTry levitated pumping in a product idea before committing to a design.
  • ResearchStirrer variantThe same floating rotor could stir a sealed vessel instead of pumping.

Where it stands

Design concepts: none of these has been built or tested yet. Every figure is calculated, simulated, taken from a part's datasheet or a design target, and each one says which. Pictures are computer renders from the CAD models. These are our own designs of known ideas; similar products and patents exist.

Designed in-house down to circuit boards, firmware and CAD. The design is proprietary to Senova Systems and is not open source. Interested in this one for your lab or product? Our email is at the foot of every page.