Menu

FT-100 levitating planar mover

A desktop tile with 36 coils that floats a 61 mm magnet puck and steers it in two directions, from a USB-C supply. For heavier loads it can slide the puck instead of lifting it.

Design concept · Research rig

Planar motors that float a carrier over a surface of coils are used in high-end factory automation. Single-magnet levitation toys show the effect but cannot steer anything. FT-100 sits in between, as a desk-sized rig for learning and demonstrations.

Thirty-six wound coils under a flat top lift a magnet puck about a millimetre and move it around within a 60 mm square. Sensors under the top read where the puck is, and the controller adjusts each coil many times a second to keep it steady.

For loads too heavy to lift for long, a glide mode lets the puck slide on the surface while the coils still steer it, at much lower power.

Design figures

Travel
±30 mm in x and y design target
Flying height
1 mm design target
Puck
61 mm, 71 g design target
Levitated payload
25 g continuous calculated
Position sensing
about 0.05 mm rms calculated
Tile
125 × 151 × 15.5 mm design target
Power
USB-C supply design target

Nothing has been built yet, so nothing here is measured.

How it works

  1. A grid of coils

    Thirty-six coils sit under a flat tile, each driven separately.

  2. Sensing the puck

    Magnetic sensors under the top track the puck's position.

  3. Lift and steer

    The controller sets every coil's current to hold the puck up and push it where it should go.

10 use cases

10 of 10 use cases

  • TeachingControl systems courseA visible, unstable system to stabilise: students see the effect of every gain they change.
  • TeachingElectromagnetism demoShow how coil current turns into force, and how many coils can share a job.
  • TeachingScience outreachA floating, moving puck explains feedback control better than a slide.
  • ResearchMulti-coil control researchTry new allocation and estimation methods on a small, real-time platform.
  • ResearchSensor-fusion experimentsWork on separating the coils' own fields from the puck's, a known hard problem.
  • Lab automationContact-free sample carrierMove a very light sample without touching anything it could pick up particles from (light loads only).
  • Product developmentPlanar motor proof of conceptA small stand-in for evaluating planar-motor ideas before building a large one.
  • Product developmentInteractive display pieceA trade-show or museum piece where an object floats and draws a path.
  • RoboticsTabletop robot baseMove a tiny tool across a surface in glide mode, steered by the coils.
  • Manufacturing and testTraining rig for planar systemsTeach technicians how industrial planar movers behave, at a fraction of the size.

Continuous levitation is limited to light loads (about 25 g, calculated) because the coils warm up; heavier loads use the glide mode.

Where it stands

Design concepts: none of these has been built or tested yet. Every figure is calculated, simulated, taken from a part's datasheet or a design target, and each one says which. Pictures are computer renders from the CAD models. These are our own designs of known ideas; similar products and patents exist.

Designed in-house down to circuit boards, firmware and CAD. The design is proprietary to Senova Systems and is not open source. Interested in this one for your lab or product? Our email is at the foot of every page.