Menu

EPG-50 zero-power magnetic gripper

An electropermanent magnet that grips steel parts on one short pulse, releases on another and holds with no power in between, with a sensor that reports whether a part is attached.

Design concept · Design study

Electropermanent magnets combine two kinds of permanent magnet and a coil. A brief current pulse flips one magnet so the pair's fields either add up at the face (on) or cancel inside (off). Nothing needs powering to stay on or off.

EPG-50 adds the electronics a factory machine expects: it runs from 24 V logic, charges a capacitor to make the pulse, and has a magnetic sensor that tells the controller whether a part is held.

Design figures

Holding force at contact
about 158 N calculated
Working load
45 N straight pull design target
Holding power
0 W for the magnet calculated
Switching pulse
about 2 ms simulated
Supply
10.8 to 30 V design target
Size and mass
44 × 51 × 32 mm, about 127 g design target

Nothing has been built yet, so nothing here is measured.

How it works

  1. Two magnets, one coil

    A strong magnet and a switchable one sit together inside a coil.

  2. One pulse flips it

    A 2 ms pulse turns the gripper on or off; no current flows while it holds.

  3. It reports back

    A sensor reads the field at the face to tell whether a part is attached.

10 use cases

10 of 10 use cases

  • RoboticsRobot arm end effectorPick steel parts with a gripper that keeps holding if the power drops.
  • RoboticsMobile robot payloadHold a steel tool or tray on a battery robot without draining it.
  • Manufacturing and testPick-and-place of steel partsMove brackets, washers and stampings between stations.
  • Manufacturing and testQuick-change fixturesClamp a steel fixture plate and release it on command.
  • Manufacturing and testPart-present checkUse the built-in sensor to confirm a part was picked before the next step.
  • Manufacturing and testSheet separationLift the top steel sheet from a stack at a test station.
  • Lab automationSteel tray handlingGrab steel-based sample trays in an automated cell.
  • Product developmentLatching mechanismA lock that stays locked with no power, for a product prototype.
  • TeachingMagnetics demoShow how magnets can be switched on and off without holding current.
  • ResearchModular robotsJoin and separate robot modules with steel faces.

Not for lifting loads over people: it has no functional-safety rating.

Where it stands

Design concepts: none of these has been built or tested yet. Every figure is calculated, simulated, taken from a part's datasheet or a design target, and each one says which. Pictures are computer renders from the CAD models. These are our own designs of known ideas; similar products and patents exist.

Designed in-house down to circuit boards, firmware and CAD. The design is proprietary to Senova Systems and is not open source. Interested in this one for your lab or product? Our email is at the foot of every page.