ZA-1 precision impedance analyzer
Measures impedance from 20 Hz to 1 MHz through four-terminal Kelvin inputs.

The ZA-1 measures the impedance of components and materials across frequency, and shows it as a reading, a sweep list or a graph of magnitude and phase.
Inside are four boards: an analog front end under its own shield, a main board with an STM32H743 microcontroller and an iCE40UP5K FPGA, a power supply, and a front keypad board. The enclosure is 3D printed and was designed for this instrument.
It is documented like a finished instrument, with a specification, theory of operation, error budget, test and calibration procedure, user manual and a design verification report. A companion program runs on a PC.
Specifications
- Frequency range
- 20 Hz to 1 MHz
- Inputs
- Four-terminal Kelvin
- Microcontroller
- STM32H743, 480 MHz
- FPGA
- iCE40UP5K
- Boards
- 4 (analog front end, main, power, front panel)
- Displays
- Reading, sweep list, magnitude and phase graph
From the ZA-1 design.
Designed in-house. The design is proprietary to Senova Systems and is not open source.
Documents
The ZA-1 is still in development: these documents describe its design (EVT-1), and it has not been built yet. Figures are design targets unless a document says they were measured.
All hardware documents- DatasheetSpecification: what it is designed to do, with its design targets and limits.
- How it worksTheory of operation, in plain terms.
- User manualSetting it up and using it.
- Design verification reportEvery check made on the design so far, and what it found.