PLS-120 printed-coil linear stage
A 140 mm linear stage whose motor coils, driver and position sensors are all one circuit board. The carriage carries only magnets and a scale strip: no screw, no belt, no moving cable.

Most small linear stages move a carriage with a lead screw or a belt, which wear, backlash and need lubrication. Direct-drive linear motors avoid all of that but are usually sold as expensive industrial axes.
PLS-120 puts the motor into the circuit board itself: fifteen coils are etched into the copper, and the same board carries the driver and the magnetic position sensors. The moving carriage has magnets underneath and nothing wired to it, so there is no cable to flex and nothing that rubs except the guide rail.
It runs from 24 V and is designed to be controlled from a computer over USB.
Design figures
- Travel
- 140 mm design target
- Continuous force
- 3.1 N calculated
- Peak force
- 6.1 N at standstill calculated
- Rated speed
- 0.5 m/s design target
- 100 mm move, 0.2 kg load
- about 0.3 s simulated
- Position resolution
- 0.49 µm per count datasheet
- Size
- 275 × 113 × 31.5 mm design target
- Supply
- 24 V DC design target
Nothing has been built yet, so nothing here is measured.
See it move
How it works
Coils in the board
Fifteen flat coils are printed into a four-layer board that runs the length of the stage.
Magnets ride above
The carriage carries a row of magnets; switching current through the coils pushes it along.
It knows where it is
A magnetic scale strip on the carriage is read by sensors on the board, so the controller closes the loop.
12 use cases
12 of 12 use cases
- Lab automationSample shuttleMove a plate, slide or cuvette between stations in a benchtop instrument without a belt to stretch or a screw to clean.
- Lab automationLiquid-handling axisCarry a pipette head along a row of wells, where smooth, quiet motion keeps drops on the tip.
- Optics and photonicsOptical bench scanningSweep a lens, mirror or detector along a rail for alignment and focus scans.
- Optics and photonicsCamera sliderA silent, cable-free slider for time-lapse, product photography or machine-vision calibration.
- Manufacturing and testInspection gantry axisStep a camera or probe across a board or part for automated inspection.
- Manufacturing and testFatigue and wear rigPush a part back and forth thousands of times with a set force to see when it fails.
- Manufacturing and testDispensing and markingDrive a glue dispenser or marker along a straight path at a steady speed.
- Product developmentPrototype actuatorA ready motion axis for a new product idea, without designing a screw drive first.
- RoboticsLinear seventh axisSlide a small robot arm or gripper along a short track to extend its reach.
- ResearchMotion experimentsRepeatable moves with full access to the controller, for testing new control methods.
- TeachingMechatronics classShow how a linear motor, a sensor and a control loop fit together on one board.
- Lab automationMicroscope stage axisMove a slide under a microscope objective for scanning, paired with a second stage for the other axis.
Where it stands
Design concepts: none of these has been built or tested yet. Every figure is calculated, simulated, taken from a part's datasheet or a design target, and each one says which. Pictures are computer renders from the CAD models. These are our own designs of known ideas; similar products and patents exist.
Designed in-house down to circuit boards, firmware and CAD. The design is proprietary to Senova Systems and is not open source. Interested in this one for your lab or product? Our email is at the foot of every page.